Now, more and more car owners consider installing reversing radar, some have a strong car owner hopes to go to do their own way to install reversing radar, and then the author will introduce how to install reversing radar, and what techniques for reverse Radar installation.
1: After checking the internal structure of the safe rod, whether there is a barrier, such as a frame beam, hit the buffer foam block, etc. Try to avoid such positions;
2: After the two ends of the hot rod are the total amount, the metric and mark the exact position of the four probes, four The spacing of the probe is equal, and on the same horizontal line, the intermediate is symmetrical in both sides, the installation surface is not too large; 
3: Adding a special drill bit The tag is opened, and the hole is repaired, press the probe number from left to right, pay attention to the up and down direction and angle of the probe; 
4: Disassemble the trunk Left-side liner and left taire, install fixed reversing radar main controller, power signal lines to reverse lighting; 
5: Relocking into the safe The probe is connected and wore to the left side of the trunk; 
6: According to the vehicle owner’s car habit, the fixed position of the radar display is generally on the left A column. Next;
7: Under the left side of the display signal or the ground pad, the display signal line is placed on the left side of the trunk, and the display and probe is sequenced. Plug picking primary controller;
8: Hanging into the reverse test radar working condition, determine each probe and display formula is normal;
9: Replace the vehicle taillight and inner lining.
Reverse Radar Installation Precautions 
The aesthetic and vehicle coordination should be considered after the radar display and the sensor installation. Most reverse radar detected between 0.4 to 1.5m, and some can even reach 0.35 ~ 2.5m, detection rangeThe wider, the sooner you can monitor when you reverse it.