1. clutch plate
As engine power is transmitted to the vehicle gearbox.
clutch plate is wearing parts cars lines, special attention to the following when using:
1, when the engine is running, the foot should not have been on the clutch pedal.
2, or a temporary stop at a red light while the engine is still in operation, place the transmission in neutral, the method of the clutch pedal can be cut without power.
3, when a clutch, in principle ldquo; fast cutting, slow binding rdquo ;. Press the pedal to the requirements altogether, lift the pedal to slow. Meng lift pedal compression spring clutch assembly is easily damaged and break the torsion spring clutch plates, while the entire system has a driving hazard. But we should try to reduce working hours and a half-clutch (clutch half of the clutch plate wear great and because of the rapid increase in temperature and increased wear, resulting in a vicious cycle).
4, the clutch plate in the course of normal wear and tear is generated, with the tapering of the clutch plate, the separation of the lever end will gradually decrease with the release bearing clearance (when you feel increasingly clutch higher) if not adjusted easily by separating the inner end of the lever is in the clutch release bearing oppressed half clutch state and the clutch plates ablation. (Recommended always let the clutch pedal free travel 20 — between 25mm).
5, if your clutch assembly has been the old parts, you need to check the clutch pressure plate if there is excessive wear (wear volume and new pressure plate ratio is not greater than 1mm).
6, check the clutch after each use return is normal, otherwise, you have to check the clutch and hydraulic steering mechanism.