The heater is a process to convert electrical energy to thermal energy. It is the use of the world’s most advanced full-cast aluminum, is independent of the automobile engine vehicle heating device has its own fuel lines, circuits, burning heating devices and control devices. No need to start the engine on cold winter cold environment parked car engine and cab preheating temperature, the complete elimination of automotive cold start wear.
1. The heater works
The working principle is to use the vehicle battery and the tank to supply a small amount of instantaneous power and the outer wire wound resistance wire stranded glass fiber reinforced refractory fiber layer, the outer layer of refractory fiber with a braided wire reinforced refractory fiber layer, in close connection with and distributed along the entire length of the resistance wire strands of the double resistance wire strands thereto cladding layer composed of a center can be freely unitary press and directly heating the monomers required bending close contact with the heating element. And circulating water is heated by the heat engine of gasoline produced by the combustion engine and thus hot start, while the temperature rise of the cab.
parking heater product advantages:
(1)Without starting the engine, the engine and the car can be preheated in advance at the same time, allowing you to open the door in the winter you can enjoy the warmth of home.
(2) Preheat more convenient, advanced remote control, timing system for car heating easily at any time, have the equivalent of a lorry warm library.
(3) prevent the engine cold starting to wear caused. Studies have shown that a cold start engine wear and tear caused by the equivalent of normal vehicle traveling 200 kilometers, 60 percentage engine wear is caused due to the cold start. So install parking heater can fully protect the engine, extending engine life of 30 percentage.
(4) to solve the problems window defrost, scraping the snow, fog wipe.
(5) environmentally friendly products, low emissions; low fuel consumption.
(6) compact, easy to install. Easy maintenance, removable car to replace the vehicle.
(7) to the vehicle transporting the summer can cool the clear, cooling for the car, a machine can achieve.
2. Use Caution
1, allowing the working member
A under the following conditions. Relative humidity less than 95 percentage, non-explosive and corrosive gases.
b. The operating voltage should be less than 1.1 times the nominal shell should be effectively grounded. .
c insulation resistance ge; 1MOmega; dielectric strength: 2KV / 1min.
2, positioning and fixing heating pipes should be prepared, the effective heating zoneIt must be completely immersed in the liquid metal or solid, non-air burning. Found pipe scale, or carbon deposition surface, should be cleaned and then, while cooling in order to avoid shortening the life IMPACT.
3, the outlet end of the heating tube magnesium oxide powder, in place of use and avoid contamination ingress of moisture, to prevent leakage accidents.
4, should be placed outside the wiring portion of the insulation layer to prevent corrosive, explosive material, contact with water; long lead wire should be able to withstand the temperature and the heating load of the wiring portion, the fastening screws should be avoided wiring too much force. When
5, or solid heat fusible metal nitrate, alkali, bitumen, paraffin and the like, should be used to reduce the voltage, after the medium to be melted, raised to the rated voltage.
6, the heating elements should cross the air uniformly arranged, so that a good heat dissipation element, the air flows can be sufficiently heated.
7, heating nitrate should consider security measures to prevent explosion.
8. The element should be stored in a dry place, if the issues long-term placement insulation resistance falls below 1MOmega; time, may be dried in an oven at about 200 ℃, ohmic heating, or reduce the voltage until the insulation resistance is restored.