The heat is full of summer, and it has come to the rainy season. The water on the road has also changed, and many owners will accelerate the accumulation of time or seek stimuli. Good luck, it has passed; the luck is not good, it will be planted in the water. What should I do if I am really unfortunate to meet the vehicle?
Method for treating car water:
1, if there is an inletation of water during water injection Immediately turn off the ignition switch, do not try to start the engine again, move the vehicle to a safe place, so that the vehicle is high and low, so that the water entering the exhaust pipe is exported to avoid damage to the three-unit catalytic converter and muffler. 2, after judgment, if the water enters the interior of the engine, the spark plug should be removed, and the artificially operates the engine as a motor to operate the engine, so that the water enters the engine inside the engine smoothly. At the same time, it is checked the fluid status of each system of the vehicle, and the phenomenon of foam, turbidity should be replaced in time.
After the detection, the compressed air is applied to remove the engine compartment interior electrical connecting member to prevent water from being causing corrosion caused by the electrical connection. The focus cleaning site is: Insurance box, sensor plug, body water storage office. After cleaning, the vehicle is taken to determine that the engine has no abnormal noise during the driving process. If there is any obvious driving noise, check the engine bearings and rotate components.
3, if the water enters the carriage in water, the maintenance process is mainly cleaned into the car water, and there are several sealing rubber blocked under the bottom of the vehicle chassis, and the plastic block can be released. 
However, since the oil absorbing material is highly water absorption, it should be removed from the ground. It is convenient to evaporate with the water. After installation, pay attention to open the air conditioner, and adjust the vehicle cycle switch to the internal cycle. This is a very fast dehumidification method in the summer.
4, the chassis member is easily deteriorated in the water-related process, and more particularly to steering, transmission and other systems. Such as the maintenance manual requires that the land cruiser must be in waterGetting the chassis member is added. At the same time, you should listen to whether there is abnormal sound from the chassis during the road test, or the chassis is disassembled.
PS:
I hope everyone should not save time to take a risk to water, especially for the gas area that is not grasped, it is wounded to damage his car and waste time. The wallet is a heavy punch, I don’t pay attention.